Bauble Earrings - 15 Minute Beginner Project - Affordable Jewellery Supplies

Bauble Earrings - 15 Minute Beginner Project

These beautiful Christmas bauble earrings are such fun to add that Christmas touch to any outfit.  Of course, you could make them in any other colour and they would no longer be Christmassy, but I love that they are.

These are super easy, perfect if you’re a beginner, and only take about 15 minutes to make.


Here’s what you will need:

  • 12mm Red (or Green) Acrylic Faceted Round Beads x2
  • 6mm Red (or Green) Acrylic Bicones x4
  • 3.5mm Gold Balls x4
  • 8mm Gold Bead Caps x4
  • 5cm Gold Headpins x2
  • Gold Earhooks x2


You will also need:

  • Round nose pliers
  • Chain nose pliers
  • Flush cutters


Watch the video or read the instructions below.

Add The Beads

Feed the beads onto the headpin in the following order:

  • Gold Ball
  • Bicone
  • Bead Cap (curve facing up)
  • 12mm Bead
  • Bead Cap (curve facing down)
  • Bicone
  • Gold Ball

Make The Loop

Using the chain nose pliers bend the headpin at the top of the beads to make a right angle.

Trim the headpin to within 1cm of the bend using the flush side of your cutters. Remember to hold each end of the wire so it doesn’t fly away.

Place the top of the headpin between the jars of your round nose pliers, making sure that the top is flush with the jaws (doesn’t poke out over the top).

Rotate the pliers away from you until your wrist won’t go any further.

Reposition the pliers so that the loop is on the lower jaw and rotate again until the loop is closed. If necessary, hold the loop with the chain nose pliers and reposition until the headpin is centered under the loop.

Attaching The Earhook

Open the loop at the bottom of the earhook by grasping it along the side with the chain nose pliers.  Rotate up towards the ceiling. Never open a loop to the side or you will lose the nice round loop.

Place the loop of the earring component onto the loop of the earhook and close then loop by rotating down toward the floor, making sure the loop sits closed. Rotate back and forth with a little pressure if necessary, to get it to sit nice and tight.

Make The Second Earring

To ensure the loops on both earrings are the same, measure where to cut the headpin using the piece you cut off the first earring. Place the earring down on the table. Line up the piece you cut off with the end of the headpin and mark where to cut with a fine tip marker. Cut the wire just before the line. This will ensure you are working with the same amount of wire as you were with the first earring and therefore the loops will be the same size.

Complete the earring in the same manner as the first.

If you liked this project, check out my other beading tutorials, either in the Create section of my blog or on my YouTube channel.  

Post a comment

Please note, comments must be approved before they are published