A few weeks ago I made some Upside Down Crystal and Chain Earrings and I was asked to make a matching necklace.
Now, you know that I'm not really a matching person when it comes to my jewellery - I like to mix it up a bit. But, I was asked and I always like to deliver, so here is the necklace to match the earrings.
Make sure you watch the video to get a 20% OFF DISCOUNT CODE on the products I used in this project.
Materials
Here’s what I used to make this necklace:
- Flower V Connector 26mm x 16mm x2
- Tibetan Silver Beaded Rondelle 6mm x 1mm x9
- Tibetan Silver Beaded Rondelle 5mm x 1mm x12
- Purple AB Electroplated Glass Faceted Rondelle x11
- Silver Stardust Beads 4mm x5
- Manmade Hemalyke Hexagonal Rondelle 3mm-4mm x5
- Silver Flat Oval Cable Chain 5mm x 3.3mm x 0.9mm x50cm
- Platinum Plated Lobster Claw Clasp 10.5mm x 5mm
- Silver Jump Rings Round 4mm x 0.8mm x17
- Silver 5cm Headpin x1
- Silver Jump Rings Round 6mm x 1.1mm x1
- Silver Beadsmith German Style Wire 22 Gauge x50cm
Tools
The tools that I used are:
Instructions
Watch the video for the full tutorial, however if you would prefer written instructions you can download those here.
Useful techniques:
Here are the techniques I used in the video. If you haven't used them before, please watch these videos.
- How to make Basic loops.
- All about jump rings.
- How to use a 1 Step Looper.
Jewellery I’m Wearing
In this week’s video, I’m wearing the summer forever necklace.
If you enjoyed this tutorial, leave me a comment below and also share, share, share.
PIN THIS FOR INSPIRATION AND SHARE WITH YOUR FRIENDS!!